Frequency Central

Notes: Chris Huggett, chief designer at EDP came up with a novel little circuit for the filter envelope of the Wasp, based around half a CD4013, half a CD4066 and half a LM3900. It was an A/R generator with looping option which would proceed through its whole cycle from only a trigger input. He further developed the circuit for the filter envelope in the Gnat to use just one knob to provide a range of attack envelopes when anti-clockwise (from 12 o'clock), and a range of release envelopes when clockwise (from 12 o'clock). 12 o'clock gives a very short symmetrical blip. As you can build two of these with a CD4013, CD4066 and LM3900, Frequency Central have provided both a two knob version and a one knob version, each has its own place.

Both envelope outputs are 0V to 5V.
All Q and not-Q outputs are 0V to 8V
Upper section cycle times: 23Hz to 20 seconds
Lower section cycle times: 8Hz to 10 seconds

Product Specifications:

Depth: 39mm
Width: 8HP
12V draw: 30mA
-12V draw: 0mA
5V draw: 0mA

Notes: Wonderland is an 8×8 active patchbay/matrix mixer/switcher for both audio and control voltages. It features:

8 inputs (1 through to 8), each with micro-attenuators (which can be set with a small screwdriver)
8 buffered inverted outputs (A through to H) which are 180o out of phase with the inputs
8 buffered normal outputs (A through to H) which are in phase with the inputs
A switch matrix of 64 push on/push off switches
Any of the 8 inputs can be patched to any of the 8 outputs simply by pressing the corresponding switches. A patched signal will appear at both normal and inverted outputs simultaneously.

A single input can be patched to a single output. A single input can be patched to multiple outputs. Multiple inputs can be patched to a single output. Multiple inputs can be patched to multiple outputs.

Each input features a micro-attenuator which can be set with a small screwdriver. This space saving feature allows you to reduce the volume of an incoming signal without having to resort to external attenuators. If you add many inputs to one output you will of course cause clipping (which may or may not be desirable!), the micro-attenuators are your on-board way around this. I find it useful to leave the micro-attenuators set to 50% (which is how they come pre-set at delivery). Of course, their size is a little bit of a compromise, but they are a useful feature nonetheless. Wonderland’s sister module Looking Glass includes full size input attenuators as well as LED status indicators.

Product Specifications
12V draw
30mA

5V draw
0mA

-12V draw
31mA

Depth
35mm

Width
18HP