100% Secure Shopping

Studio equipment

Our full range of studio equipment from all the leading equipment and software brands. Guaranteed fast delivery and low prices.

Visit Juno Studio

100% Secure Shopping

DJ equipment

Our full range of DJ equipment from all the leading equipment and software brands. Guaranteed fast delivery and low prices.Visit Juno DJ

Synth module accessories

View:
Options
Items 1 to 19 of 19 on page 1 of 1
Cat: 698459 Rel: 08 Aug 18
 
Universal low-impedance bus board
Notes: The ACL EVE 1 busboard is used to distribute the operating voltages of a power supply unit to supply up to 20 modules in a Eurorack case.

It was developed with the aim of achieving the lowest possible electrical contact resistance between the power supply unit and the modules connected to it.

This is reflected in minimal potential differences between the power supply unit and between all connection terminals of the modules and the terminals, which almost completely eliminates any couplings between modules and the resulting interference.

This is achieved by a six-layer sandwich design in which each voltage supplied by the power supply unit has its own complete layer for distribution to the module connection terminals, i.e. +12V, -12V and +5V each have the complete surface of the bus board available as copper surface, while the ground even has three layers available, resulting in an extremely low resistance of the ground bar (ground). The arrangement of the layers is like a sandwich, there is almost no influence between e.g. the +5V rail on which often disturbing digital modules are connected and ground or the +/- 12V rails. In addition, there are 4 buffer capacitors with 22uF and 100nF each for the +12V and -12V rail, which are arranged as parallel connected packets with 22uF and 100nF each at the outer ends left and right. These capacitors are Ultra Low ESR MLCC types.

Furthermore, a CV and a gate bus are available up to four times (two at the top and two at the bottom, each bridged by a jumper). These are consequently shielded from each other and from the voltage bars and thus cannot influence each other or other voltage bars (+/- 12V, +5V) by crosstalk, which further rounds off the "low-noise design".
Read more
 1 in stock $77.57
ACL Kazu To EVE1 Connection Cable (module connection cable)
Cat: 698460 Rel: 08 Aug 18
 
Module connection cable
Notes: This cable is needed to connect the ACL KAZU PSU module to the EVE busboard. The cable is equipped with two five-pin connectors, which are compatible to KAZU and EVE-1.

Module and bus board are not included.
Read more
 1 in stock $11.69
Cat: 675764 Rel: 13 Apr 18
 
88 HP comprehensive Eurorack case with 5 HP power module & Arturia Link system
Notes: RackBrute 3U is a comprehensive Eurorack housing, transport, and protection solution. Featuring configurable positions, dependable power supply, and maximum practicality, you can be assured your precious modules will be well guarded.

Modular gear is a precious commodity, and you need a versatile housing and security system to accommodate them. A first glance, you'll see that this is a perfectly fitted 3U, 88 HP case made of a light but strong aluminium chassis, fitted with wood side panels. Deceptively simple, RackBrute is far more than a simple box. It includes many smart additions, such as the included +12V / -12V / +5V power supply that ensures that keeps everything up and running, and the multi-position handle system that not only lets you carry your collection with ease, but also lets you deploy an optimal operating angle, whatever your preference.

In addition to keeping your modules safe and secure, RackBrute 3U gives you total control of the situation, no matter the context. The first of its secret weapons is the Link fastening system. Paired with the included handle, it will let you choose one of several configurations and orientations for your modular arsenal. Whether you want your gear stealthy and prone, or standing to attention, RackBrute is at your command.

The second trick up its sleeve is the stalwart, ever-reliable, power supply module. Including two independent circuits to supply common modular voltages, it will more than cover your need for +12V, -12V and +5V, providing up to 1600mA in total.

Thirdly, its robust power rail includes sophisticated noise-filtering technology and provides 20 standard slots to leave plenty of space for your collection.

Once you're powered, in position, and locked down, you'll feel like your modular rig could withstand a siege.

The Link fastening system not only equips the RackBrute 3U, but also its large-calibre sibling, RackBrute 6U as well the MiniBrute 2 and MiniBrute 2S. No matter the combination you go for, you can make the most out of your extensive module collection, or create a powerful EcoSystem with the extensive CV/Gate connectivity of the MiniBrute 2 and 2S.
Read more
 1 in stock $210.44
Cat: 675765 Rel: 13 Apr 18
 
176 HP all-inclusive Eurorack case with 5 HP power module & Arturia Link system
Notes: RackBrute 6U is an all-inclusive Eurorack case ensuring the total security of your modules and maximum practicality in all conditions of use. Its multi-position configuration and included dependable power supply make it the true specialist solution.

RackBrute 6U provides you with 176HP to store and secure your enviable collection of Eurorack modules in an everlasting yet lightweight aluminium chassis flanked by two wood panels. Once you're locked and loaded, your modular setup will look and feel like a monolith, yet more flexible than ever thanks the Link fastening system and the paired handle. When on the move, it will make the transport of your modular equipment a walk in the park. When in position, it will let you organize your command centre the way you want it. Modules don't live on love alone, and RackBrute 6U keeps everything alive with its +12V / -12V / +5V power supply.

When you have to hold your position for hours, it's better to be well set up and to have a clear view of the surroundings. For this reason, Arturia developed the Link system, a convenient and simple-to-use fastening system that allows you to orientate the dedicated handle so that you can give your modular the most tactically advantageous position. Whether prone, crouching, or standing to attention, RackBrute 6U will always be on the lookout, ready for orders.

Troops are nothing if they are not properly fed. No problem, RackBrute 6U is not just a box. It includes a formidable +12V / -12V / +5V power supply ensuring your firepower up to 1600mA. This is coupled with a military-grade power rail with 32 available slots, including advanced noise filtering technology that guarantees optimum conditions.

With RackBrute 6U, even the most headstrong modules fall into line.

The RackBrute 6U fully takes advantage of the Link System, and it's not alone. You'll also find the Arturia Link on the more compact RackBrute 3U, as well as the self-contained MiniBrute 2 and MiniBrute 2S synthesizers. What solution will you go for? Will your field of operations be fully based on Eurorack, or the powerful force of analog monosynth flagship supported by a fleet of complementary modules?
Read more
 5 in stock $297.33
Cat: 695389 Rel: 18 Jul 18
 
Passport 5V adapter
Notes: The coolest solution for +5V needy modules! Bastl's new tiny adaptor can convert +-12V from your power supply into +5V, and it can access the powerline on your bus board and feed all modules connected to it. Optionally it can feed only one single module through the in-built pin connector, while leaving the +5V line on your bus board untouched. In both situations it will perform flawlessly, and you can change the setting anytime with dedicated jumper.
Read more
 1 in stock $15.94
Cat: 695388 Rel: 18 Jul 18
 
Plywood case for Eurorack modules
Notes: Outside dimensions: 385 (width) x 280 (length) x 110 (height) mm

Inside dimensions: 2 x 72 HP, 100 mm depth (approx. 60 mm in the power supply area)

Material: plywood, 10 mm (thick)

Electrical parameters:

Input: 100-240V AC

Output voltages/current: +5V/5000mA, +12V/2800mA, -12V/500mA
Read more
 1 in stock $235.91
Cat: 614713 Rel: 20 Jun 16
 
Eurorack synth module case, with built-in power supply - 104HP wide
Notes: Desktop Eurorack moduile case 3U - 104HP with power supply on the left side.

Plexiglas side panels 5mm thick.

Aluminium chassis.

6cm deep, but only 4cm deep all along the 5HP of the power supply. Check your modules before!

Tech specs:
- Width : 104HP
- Depth : 6cm
- Depth all along the 5HP of the power supply : 4cm
- Current Consumption : +12V : 2.4A ; -12V : 1.2A ; +5V : 0.5A
Read more
 1 in stock $206.16
Cat: 695368 Rel: 01 Aug 18
 
Angled 2 x 84 HP Eurorack case with PSU & power cord
Notes: Eowave Studio Cases are made of metal, with wooden side panels to give them a modern look. The case here is angled, and features two rows with 84 HP each. A power supply and Bus Boards are built-in.
Read more
 3 in stock $232.72
FORTHCOMING
Frap Tools Black Plastic Washers (pack of 100)
e-mail me when released
coming soon $10.10
Cat: 557526 Rel: 19 Dec 14
 
10hp blank panel for modular synth system
Notes: 10hp blank panel for modular synth system
Read more
 2 in stock $10.89
Cat: 593467 Rel: 21 Dec 15
 
104hp synthesizer module case with built-in power
Notes: In 2009 Tony designed the first Skiff to complement the vertically oriented cases available at the time by providing an ergonomic enclosure for our Rene and Pressure Points touch controllers.

Today the Make Noise Skiff provides a smart way to build a small modular synthesizer. It is low cost, but extremely durable. The clean simple lines and matte black color place visual emphasis where the action is: the patch the artist has created. At one side there is a power button and the Make Noise logo is illuminated to show the power is ON.

Ships ready to use. Just add modules, patch cables, and inspiration.
Read more
 2 in stock $231.66
Cat: 598247 Rel: 08 Mar 16
 
Lifeforms logo blank panel - 6HP wide
Notes: Lifeforms HP-6

A 6HP logo panel manufactured using the same custom matte aluminium finish and logo graphic as the Lifeforms modules line.


Panel size 6hp
Read more
 2 in stock $14.88
Cat: 619258 Rel: 05 Jul 16
 
84HP Eurorack case with rugged aluminium construction and wooden side panels
Notes: Durable Eurorack case with super-clean, high capacity power supply:
From studio production to live performance, Eurorack-based modular synthesis has exploded in popularity around the world. For portability, protection, and usability, a quality case and power supply is an essential part of every modular synth rig. With the SYR-E84, Roland introduces its first Eurorack case, which integrates a durable, lightweight design and a super-clean power supply with high capacity for today's power-hungry modules. The SYR-E84 fits AIRA modular electronic instruments such as the SYSTEM-1m, BITRAZER, DEMORA, TORCIDO, SCOOPER, and SYSTEM-500, as well as standard Eurorack modules from other manufacturers.

Featuring a rugged black aluminium enclosure and wood side panels, the SYR-E84 offers top-level looks and performance for modular synth starters and seasoned pros alike. Specially designed for modular instruments, the high-capacity DC supply provides stable, low-noise power that meets Roland's discriminating quality standards, delivering clean and reliable operation you can count on. The versatile case can be used in flat, angled, or vertical positions to meet any working situation, and offers easy stacking capabilities for expanding your setup in the future.
Read more
 2 in stock $298.44
Cat: 595831 Rel: 19 Jan 16
 
Power Cable with one 10 pin header and one 16 pin header for your module
Notes: Power Cable with one 10 pin header and one 16 pin header for your module.
Read more
 2 in stock $5.05
Cat: 640233 Rel: 06 Feb 17
 
Cable version of a distribution PCB (printed circuit board) - long
Notes: TipTop's Flying Bus Board is a cable version of a distribution PCB (printed circuit board) and extends the reach of one of your uZeus cables or adds a third row.
Read more
 5 in stock $13.81
Cat: 595829 Rel: 19 Jan 16
 
Cable version of a distribution PCB (printed circuit board) - short
Notes: TipTop's Flying Bus Board is a cable version of a distribution PCB (printed circuit board) and extends the reach of one of your uZeus cables or adds a third row.
Read more
 5 in stock $13.81
Cat: 693139 Rel: 02 Jul 18
 
Delay/reverb expansion card for the TipTop Audio Z-DSP Digital Signal Processor
Notes: Mariana Trench is an FDN card for the Z-DSP. Feedback Delay Networks (FDNs) are built around multiple delays which are connected to their inputs thanks to a feedback matrix designed for its stability and lossless properties. FDN can mimic the recursive process of sound waves bouncing back and forth in an acoustic space. They were first suggested for artificial reverberation by Michael Gerzon (1971) and later John Stautner and Miller Puckette (1982) introduced four-channel FDN reverberator with general stability conditions.

FDN can also be used as a special case of digital waveguides, they can be tuned, or also used as complex delays. The Mariana Trench Z-DSP cartridge is designed to explore these more unusual sides of the FDN algorithms. Mariana Trench Z-DSP cartridge is designed by Christophe Duquesne Anckorage - Haken Audio developement team - La Voix du Luthier.
Read more
 2 in stock $69.07
Cat: 595808 Rel: 19 Jan 16
 
3U rack ears for use as either tabletop or rack mount frame
Notes: The Z-Ears Tabletop are standard 3U rack ears that can be used as either a tabletop frame or standard rack mount frame. These parts are made of anodized aluminium and are custom made to work with Eurorack mounting rails like Z-Rails.
Read more
 2 in stock $20.18
Items 1 to 19 of 19 on page 1 of 1

Filter

Synth module accessories
Equipment
Release Date
Featured
Monthly payment
Number of monthly payments
Cash price
Deposit to pay
Loan amount
Loan repayment
Cost of loan
Total amount payable

Only available to UK residents over 18, subject to terms and conditions. More info here.

These rates of finance are based on this specific product and can be applied for once this item has been added to the cart. Adding other products to your cart may change the rate of finance or deposit required.

Checkout and apply for finance now
Close